I have updated all the ankle parts to use metric dimensions instead of inches.
There are now three metric versions of the files:
0.125' → 3 mm
0.250' → 6 mm
0.188' → 5 mm
Because of the height loss caused by the unit conversion, a third part (labeled G in the assembly guide) is now required to fill the gap in the stack.
Even with this added part, the full metric ankle assembly is still 0.54 mm shorter than the original inch-based version, but this should not be critical in practice.
All of this is WIP: it has not been printed or physically tested yet.
I am sharing it so others can review it and give feedback before it is validated.
If you spot anything that looks wrong or inconsistent, please let me know.
.dxf files:
Scavenger_Ankle_Plates_6mm.dxf- (155.45 KiB) Downloaded 7 times
- Scavenger_Ankle_Plates_5mm.dxf
- (88.77 KiB) Downloaded 8 times
- Scavenger_Ankle_Plates_3mm.dxf
- (155.82 KiB) Downloaded 8 times
New part added in the 3mm .dxf
